Filter
Top Products
Removing the Dual Purpose Forms Device (F2)
Note: If you are removing this forms device to install a different
forms device, make sure you change the selected forms device in
the Configuration Menu.
To remove the F2 forms device, follow these steps:
1. If forms are in the printer, unload them (see “Unloading Forms”
on page 1-81), then continue with Step 2 of this procedure.
2. Turn the power Off (O).
3. Open the access cover. Then open the front paper door as
follows:
a. Pull the door up until it will not go any higher.
b. Push the door back slightly to lock it in the open position.
Access C over
Paper Door
Chapter 1. Setting Up the 4232 Printer Model 302 1-83