Filter
Top Products
d. Press Stop.
The printer may display
and then
Ignore these messages until you have attached the printer to
your computer. (Press Stop to turn off the alarm, if
necessary.)
5. If the printer operated correctly, go to Step 6 on page 1-14,
otherwise, check the following:
Operator Note
If you turned the power Off (O) and back On (|) in
less than
10 seconds
, the display may be blank or a message may
appear.
If the power-on messages do not appear in your language,
see “Using Printer Setup Parameters” in
IBM 4232 Printer
Model 302 Operator Panel Instructions
to change the Display
Language.
a. Did the printer come on after you turned the power On (|) in
Step 4 on page 1-12?
If
Yes
, go to Step 5b on page 1-14.
If
No
, perform Steps 5a1 through 5a6 on page 1-14.
1) Turn the power Off (O).
2) Unplug the printer power cord from the electrical outlet.
3) Be sure that the power cord is firmly connected to the
rear of the printer.
9 COVER/DOOR OPEN
PRINT SPEED REDUCED
| 29 LINK ERROR
Chapter 1. Setting Up the 4232 Printer Model 302 1-13