Filter
Top Products
4. Look through the front bottom opening in the printer and find the
metal bar
at the bottom of the forms device.
5. Grasp the
metal bar
with BOTH hands and pull firmly toward you
and then upward until both ends LOCK into place.
Bottom of Form s Device
MetalBar
6. To be sure that you have installed the forms device correctly,
look at the following figure and compare it to your printer. Check
both the left and right sides. Are the
clips
around the
platen rod
as shown? If so, you installed the forms device correctly. If not,
repeat Steps 3 on page 1-54 through 5.
Platen Rod
Clip
Platen Rod
Clip
Chapter 1. Setting Up the 4232 Printer Model 302 1-55