Lexmark E460dw Printer User Manual


 
Standard Bin Full
Remove the stack of paper from the standard exit bin to clear the message.
Stopping
Wait for the message to clear.
Submitting selection
Wait for the message to clear.
Too many failed panel logins
The printer is now in a lockout mode because:
You attempted to log in too many times with an incorrect PIN
You attempted to log in using an incorrect password number for access to a printer feature, setting, or menu that
you do not have access to.
Note: There is a defined limit on the number of login attempts. Once the limit is reached, this message appears and
the printer enters a lockout mode. The message remains on the printer control panel, and any further attempts to
enter menus is denied until the defined time out expires. The time out duration is set by your system support person.
Wait for the message to clear once the time out expires, and then:
Enter the correct PIN to access any held jobs
See your system support person if you need a password number to enter a specific printer feature, setting, or
menu that is blocked from your use without the number.
Tray <x> disabled
The specified tray is disabled from the Disable Hardware menu of the Config menu. To clear the message, enable the
specified tray through the same menu. Consult your system support person for help.
Tray <x> Missing
Insert the specified tray into the printer.
30.yy Invalid refill, change cartridge
An unsupported, refilled toner cartridge is installed. Remove the toner cartridge, and then install a new one.
31.yy Replace defective or missing cartridge
The toner cartridge is either missing or not functioning properly.
Try one or more of the following:
Remove the toner cartridge, and then reinstall it.
Remove the toner cartridge, and then install a new one.
Troubleshooting
141