Filter
Top Products
Administrative support
Finding advanced networking and administrator
information
This chapter covers basic administrative support tasks. For more advanced system support tasks, see the Networking
Guide on the Software and Documentation CD and the Embedded Web Server Administrator's Guide on the Lexmark
Web site at www.lexmark.com.
Adjusting Power Saver
1 Make sure the printer is on and Ready appears.
2 From the printer control panel, press .
3 Press the arrow buttons until Settings appears, and then press .
4 Press the arrow buttons until General Settings appears, and then press .
5 Press the arrow buttons until Timeouts appears, and then press .
6 Press the arrow buttons until Power Saver appears, and then press .
7 Press the arrow buttons to increase or decrease the number of minutes before the printer enters Power Saver
mode, and then press
. Available settings are Disabled and a range from 1–240 minutes.
Note: Power Saver settings can also be adjusted by issuing a Printer Job Language (PJL) command. For more
information, see the Technical Reference available on the Lexmark Web site at www.lexmark.com/publications.
Restoring the factory default settings
1 From the printer control panel, press .
2 Press the arrow buttons until Settings appears, and then press .
3 Press the arrow buttons until General Settings appears, and then press .
4 Press the arrow buttons until Factory Defaults appears, and then press .
5 Press the arrow buttons until Restore Now appears, and then press .
Wait for Submitting Changes to appear momentarily, followed by Restoring Factory Defaults,
before the printer returns to Ready.
Warning—Potential Damage: Restore Now returns all printer settings to the factory default settings except
Network/Port menu settings. All downloads stored in RAM are deleted. Downloads stored in flash memory are
not affected.
Administrative support
106