Lexmark 120n Printer User Manual


 
Overview of the Lexmark E120n operator panel
32
Using the operator panels
Programming engine code or system code
Restoring factory defaults
Cartridge region mismatch
Light sequence:
Ready / Data—On
Error—On
Message:
New code is being programmed into the engine or firmware.
Solution:
Wait for message to clear. When printer has finished programming the code, it returns to ready.
Note: No buttons are active while this message is displayed.
Light sequence:
Continue—On
Ready / Data—On
Toner Low/Replace PC Kit—On
Load / Remove Paper—On
Paper Jam—On
Error—On
Message:
Printer is resetting to the original factory default settings.
Solution:
Wait for message to clear.
Light sequence:
Toner Low/Replace PC Kit—Blinking
Error—Blinking
Message:
The toner cartridge being used is not programmed for the specific region.
Solution:
Remove the toner cartridge, and install a new toner cartridge that is programmed for the same region as your
printer. See the back of the printer for a label with your printer region location. See Ordering supplies on page 66
for a list of correct supplies and part numbers.