Filter
Top Products
171
Power Saver
Purpose:
To specify the amount of time (in minutes) the printer waits after a job is printed before it goes into a
reduced power state.
Values:
The factory default Power Saver setting depends on your printer model. Print the menu settings page
to determine the current Power Saver setting. When the printer is in Power Saver mode, it is still ready
to receive print jobs.
Select 1 to put the printer in Power Saver mode one minute after it finishes a print job. This uses much
less energy, but requires more warm-up time for the printer. Select 1 if your printer shares an electrical
circuit with room lighting and you notice lights flickering.
Select a high value if your printer is in constant use. Under most circumstances, this keeps the printer
ready to print with minimum warm-up time. Select a value between 1 and 240 minutes if you want a
balance between energy consumption and a shorter warm-up period.
Print Area
Purpose:
To modify the logical and physical printable area.
Values:
Note: The Whole Page setting only affects pages printed using PCL 5 interpreter. This
setting has no effect on pages printed using the PCL XL or PostScript interpreters.
If you try to print any data in the non-printable area defined by Normal Print Area,
the printer will clip the image at the boundary defined by the Normal defined
printable area.
See also:
Technical Reference
1...240 Specifies the amount of time after a print job before the printer goes into Power Saver
mode. (Your printer may not support the entire range of values.)
Normal*
Whole Page