Filter
Top Products
Operation
39
Remote Monitor
The Remote Monitor Panel (optional) displays eight (8) alarms. These alarms are also available for
customer use through a set of contacts on a separate terminal board.
The following alarms, as well as those listed above, will activate the System Summary Alarm.
When the New Alarm, System Summary Alarm or Module Summary Alarm is activated, you can get
more information at the Operator Display Panel or through a remote terminal. Refer to 3.2.14 - Com-
munication Interfaces.
Table 1 Alarm messages
Standard Remote Monitor Indications Channel
Load On UPS CH1
Load On Bypass CH2
Battery Discharging CH3
Low Battery Warning CH4
Overload CH5
Ambient Overtemp CH6
System Summary Alarm CH7
New Alarm CH8
Table 2 Additional alarm messages
Battery CB Open
Blower Failed
Control Power Fail
DC Capacitor Fuse Blown
DC Ground Fault
DC Overvoltage Shutdown
Emergency Off
Equipment Overtemperature
Static Switch Unable
Inverter Fault
Low Battery Shutdown
Output Overvoltage
Output Undervoltage
Overload Shutdown
Overload Transfer
Rectifier Fuse Blown
Reverse Power