Filter
Top Products
Operation 49
Date
This is the system’s real-time date setting. The system control program sends to each module the date entered at
the System Control Cabinet (SCC). You cannot change the system date from the control panel of a UPS module.
Figure 30 Date Screen
To reset the date, do the following at the SCC.
1. From the System Configuration screen, press the Up or Down pad to move the highlighted cursor to DATE.
2. Press the Select pad. The Date screen will appear.
3. Press the Select pad to move the arrow to the next digit to the right.
4. When the arrow is on the digit to be changed, press the Up pad to increase the number or the Down pad to
decrease it. Press Select to set the value and move to the next digit.
5. After the correct month/day/year has been set, press the Select pad again to return to the System
Configuration screen.
NOTE
Precise Date and Time functions are required for accurate archive and event history
purposes.
Both the Date and Time can be set from a remote terminal. Refer to 3.1.14 -
Communication Interfaces.
All Liebert Series 600T products can handle dates past the year 2000.
DATE
INCREASE VALUE
DECREASE VALUE
WALK-THRU/ EXIT
UP :
DOWN :
SELECT :
01/17/96