Filter
Top Products
ADSL Gateway with Modem / Router / 4-Port Switch / Wireless-Ready
7
Instant Broadband
™
Series
6
Power Green. The Power LED lights up when the Gateway is pow-
ered on.
Diag Green. The Diag LED flashes when the Gateway is booting
up. If this flashes or stays solid after the bootup phase, the
Gateway may be malfunctioning. See “Appendix A:
Troubleshooting” if you encounter this problem.
Link/Act Green. The Link/Act LED serves two purposes. If the LED
is continuously lit, the Gateway is successfully connected to
a device through the corresponding port (1, 2, 3 or 4). If the
LED is flickering, the Gateway is actively sending or receiv-
ing data over that port.
Full/Col Green. The Full/Col LED also serves two purposes. If this
LED is lit up continuously, the connection made through the
corresponding port is running in Full Duplex mode. If the
LED flickers, the connection is experiencing collisions.
Infrequent collisions are normal.
100 Green. The 100 LED lights up when a successful 100Mbps
connection is made through the corresponding port.
If this LED does not light up, then your connection speed is
10 Mbps.
WLAN Link Green. This LED is solidly lit when a wireless PC Card is
inserted and functioning in the Gateway.
WLAN Act Green. This LED flashes when there is wireless activity.
The Gateway’s Front Panel LEDs
Figure 2-2
Chapter 2:Getting to Know the
ADSL Gateway with Modem / Router / 4-
Port Switch / Wireless-Ready
The Gateway’s ports, where network cables are connected, are located on the
back panel of the Gateway.
ADSL The ADSL port is where you will connect your
ADSL line.
Ports 1-4 These four LAN (Local Area Network) ports con-
nect to network devices, such as PCs, print servers,
and remote hard drives.
Power The Power port is where you will connect the
power adapter.
On/Off Switch This switch is used for turning the Gateway on and
off.
PC Card Slot This is where you can connect the optional wireless
PC card (not included) for wireless features.
The Gateway’s Back Panel Ports
Figure 2-1