Filter
Top Products
17
3. Select
ON or OFF and press ENTER, which will take you back to the
main display.
4. If you choose to keep the current setting, press
EXIT to return to the
Audio Setup menu
Adjusting Alarm Sounds:
1. To turn on or turn off Alarm Sounds, select
ALARM SOUNDS from the
Audio Setup menu and press
ENTER.
2. Select
ON or OFF and press ENTER, which will take you back to the
main display.
3. If you choose to keep the current setting, press
EXIT to return to the
AUDIO SETUP menu.
4. Press
EXIT repeatedly to return to the main display.
System Setup
On each page, the System Setup menu contains, Engine Displayed,
Change Units, Bus Devices, Sonar Alarms, Eng/Tank Configuration,
Reset Values
and System Information.
To access the System Setup menu, press
MENU and use the UP and
DOWN keys to highlight SYSTEM SETUP, then press ENTER. We’ll discuss
the System Setup menu in more detail in the Advanced Operation
section.
Bus Devices
One of the more significant commands in the System Setup menu is the
Bus Devices command. It allows you to run a system check for all
devices connected to the LowranceNet.
1. To run a system check for devices connected to the NMEA 2000
LowranceNet, press
MENU, select SYSTEM SETUP and press ENTER. Choose
BUS DEVICES and press ENTER. After a Searching for Bus Devices
message comes up, a list of all devices attached to the LowranceNET —
the Bus Devices list — will appear.
NOTE:
If you modify settings and are not satisfied with the results, you
can reset the gauge to its factory default settings via the Reset
Values command.
To Reset Values:
1. Press
MENU, highlight SYSTEM SETUP and press ENTER.
2. Scroll down to
RESET VALUES and press ENTER. The following message
will appear: Press Enter to reset all values.
3. Press
ENTER to reset the values.