Filter
Top Products
Setting DIP Switches
To change the DIP switch settings, move the switches to the
desired position and then turn on the printer.
If you select Software Controlled, the parameters in Packet F will
override the communication settings. Software Controlled uses
the last sent Packet F settings or the defaults. Turning on the
printer activates the DIP switch settings. Make sure the DIP
switch settings match the printer’s setup for ribbon or supply type.
Upper DIP Switches
12345678
Baud Rate
38400
19200
9600
4800
2400
1200
Software Control
ON
ON
ON
OFF
OFF
OFF
OFF
ON
OFF
OFF
ON
ON
OFF
OFF
OFF
ON
OFF
ON
OFF
ON
OFF
Data Bits
7 Data Bits
8 Data Bits
ON
OFF
Stop Bits
2 Stop Bits
1 Stop Bit
ON
OFF
Parity
Even
Odd
None
ON
OFF
OFF
OFF
ON
OFF
Parallel Port
Centronics Mode
IEEE-1284
OFF
ON
Communication settings at the printer must match those at the host.
Make sure your host is capable of communicating at the speed you
select for the printer.
Getting Started 1-5
Rev. B 12/97