Monarch 9800 Series Printer User Manual


 
703 The printer sensed a calibration of different-sized black
marks.
704 Printer didn’t detect a sense mark within the maximum
feed length or is out of supplies. Check or load
supplies.
705 Invalid batch received.
750 Printhead is overheated, turn off the printer to let it cool.
751 Printer didn’t detect a sense mark when expected.
752 Printer detected a sense mark in the wrong place.
753 Printer detected a sense mark that is too long.
754 Out of ribbon or ribbon jam. Check or load ribbon.
Remove any slack in the ribbon by turning the take-up
reel clockwise.
755 Printhead is open. Close the printhead.
756 Out of supplies. Load supplies.
757 Reload supplies (supply length mismatch).
758 The supply was not seen or the on-demand sensor is
not working correctly. Check for a supply jam. Clear
the supply path or reload supplies. This error may
occur if you remove a label too quickly in the
on-demand mode. The printer does not recalibrate
after this error.
759 Knife is not moving. Call Technical Support.
760 Knife jam. Remove any jammed tags from the knife.
Call Technical Support.
761 Stacker is full or jammed. Empty the stacker or clear
the jam before continuing. The printer does not
recalibrate after this error.
Troubleshooting 6-13
Rev. B 12/97