Filter
Top Products
For fan-fold supplies, lay the label strip over the supply
holder and across the supply guide so that a few inches
extend past the front of the printer. Tuck the supply under the
nibs and in between the die cut sensor.
For tag supplies using the optional knife, feed the supply
through the knife. Make sure at least 0.5 inches of supply is
past the knife.
8. Adjust the supply guides so they touch the supply. Push up
on the supply lever to lock the supply guides into place.
Nibs
Supply Lever
Die Cut
Sensor
Tag
2-4 Loading Supplies
Rev. A 10/98