Filter
Top Products
3. Lift printhead assembly using the printhead tab until the
assembly locks into place.
4. Push the deflector tab down.
5. Slide the extra ribbon core on the take-up reel as far as it will
go with the "Monarch This End Out" writing facing out. Use
your empty ribbon core as the take-up core. The take-up core
only fits on the take-up reel one way. (An extra take-up core
is available by ordering part number 117961.)
6. Remove the new ribbon from the package as shown. Do not
wrinkle or crush the new ribbon.
Printhead Tab
Deflector Tab
Loading Ribbon 3-3
Rev. B 12/97