Clearing Label Jams
When you are printing and a jam occurs, the Supplies light on the
printer’s front panel blinks. To clear the jam:
1. Turn off the printer.
2. Open the cover and printhead assembly.
3. If necessary, remove the label roll and ribbon.
4. Remove the jammed labels and reload the label roll.
5. Close the printhead assembly and turn on the printer.
6. Press Feed to position the supply under the printhead.
Cleaning
The rate and frequency at which you print determines how often
you must clean the printer.
You may need to clean the printhead and platen roller:
◆
if there is any adhesive build-up in
the supply path
◆
after printing approximately six rolls of
supply, after using two ribbons, or
whenever you load new supplies
◆
daily if your printer is in an excessively
dirty, hot, or humid environment
◆
when you see voids in the print as shown.
You may have to clean the supply sensor more often if you
frequently receive supply error codes.
5-2 Care and Maintenance
Rev. B 12/97