Filter
Top Products
Owner’s Manual
30 MT5634ZPX-PCI
9. If you are required to dial 9 to get an outside line, edit the dialing
prefix to include a 9 and a comma, e.g., ATDT9, (the comma
inserts a pause before dialing the next digit).
Similarly, to turn off call waiting for the duration of the call, insert
the disabling code used in your area, e.g., ATDT*70,. If you are
using Windows 95-compliant software, make these changes in the
How I dial from this location box of Dialing Properties.
Note: *70 is used only in the United States.
Remote Configuration
Remote configuration is a network management tool that allows you to
configure modems anywhere in your network from one location. With
password-protected remote configuration, you can issue AT commands
to a remote MT5634ZPX-PCI modem for maintenance or
troubleshooting as if you were on-site.
Basic Procedure
Use these steps for connections established by the local or by the
remoteMulti-Tech modem.
1. Establish a data connection with a remote MT5634ZPX-PCI
modem.
2. Send three remote configuration escape characters followed by
AT and the setup password. Then press ENTER. Example:
%%%ATMTSMODEM<cr>. You have four attempts to enter
the password correctly before being disconnected. If the password
is correct, the remote modem responds with OK.
3. You now can send AT commands to configure the remote modem.
4. When you finish configuring the remote modem, save the new
configuration by typing AT&W0<cr>. Then type ATO<cr> to
exit remote configuration. You can then break the connection in
the normal way.
CAUTION: Hanging up while you are in remote configuration
mode can lock up the remote modem.