Filter
Top Products
2 Installation
5
MultiModemZPX User Guide
Step 1: Install the MultiModemZPX in your Computer
Figure 2-1. The MultiModemZPX.
Installing the MultiModemZPX requires you to open your computer. Please consult
your computer manual in addition to the following instructions.
1. Turn off the computer and unplug it. Failure to do so may result in damage to
both the MultiModemZPX and the computer. Do not turn on the computer until
the instructions tell you to do so.
2. Remove the cover from the computer as instructed in the computer manual.
3. Select an empty PCI expansion slot. Remove the expansion slot cover and save
the retaining screw.
4. Before handling the MultiModemZPX, discharge static in your body by touching
a metal piece of the computer chassis. Carefully remove the MultiModemZPX
from its antistatic bag, handling it only by the mounting bracket and edges. Do
not touch the gold-plated connectors along the bottom edge.
5. Place the MultiModemZPX directly above the expansion slot and gently, but
firmly, push it into the connector until the card’s retaining bracket is flush
against the computer chassis.
6. Fasten the retaining bracket to the computer chassis with the screw saved in step 3.
7. Replace the cover of the computer.