Filter
Top Products
4 AT Commands, S-Registers, and Result Codes
43
MultiModemZPX User Guide
Result Codes
In command mode your modem can send responses called result codes to your com-
puter. Result codes are used by communications programs and can also appear on
your monitor.
Terse Verbose Description
0OK Command executed
1 CONNECT Modem connected to line
2 RING Ring signal detected
3 NO CARRIER Carrier signal lost or not detected
4 ERROR Invalid command
5 CONNECT 1200 * Connected at 1200 bps
6 NO DIALTONE No dial tone detected
7 BUSY Busy signal detected
8 NO ANSWER No answer at remote end
10 CONNECT 2400 * Connected at 2400 bps
11 CONNECT 4800 * Connected at 4800 bps
12 CONNECT 9600 * Connected at 9600 bps
13 CONNECT 14400 * Connected at 14400 bps
14 CONNECT 19200 * Connected at 19200 bps
24 CONNECT 7200 * Connected at 7200 bps
25 CONNECT 12000 * Connected at 12000 bps
26 CONNECT 16800 * Connected at 16800 bps
40 CONNECT 300 * Connected at 300 bps
55 CONNECT 21600 * Connected at 21600 bps
56 CONNECT 24000 * Connected at 24000 bps
57 CONNECT 26400 * Connected at 26400 bps
58 CONNECT 28800 * Connected at 28800 bps
59 CONNECT 31200 * Connected at 31200 bps
60 CONNECT 33600 * Connected at 33600 bps
70 CONNECT 32000 * Connected at 32000 bps, 56K rate
71 CONNECT 34000 * Connected at 34000 bps, 56K rate
72 CONNECT 36000 * Connected at 36000 bps, 56K rate
73 CONNECT 38000 * Connected at 38000 bps, 56K rate
74 CONNECT 40000 * Connected at 40000 bps, 56K rate
75 CONNECT 42000 * Connected at 42000 bps, 56K rate
76 CONNECT 44000 * Connected at 44000 bps, 56K rate
77 CONNECT 46000 * Connected at 46000 bps, 56K rate
78 CONNECT 48000 * Connected at 48000 bps, 56K rate
79 CONNECT 50000 * Connected at 50000 bps, 56K rate
80 CONNECT 52000 * Connected at 52000 bps, 56K rate
81 CONNECT 54000 * Connected at 54000 bps, 56K rate
82 CONNECT 56000 * Connected at 56000 bps, 56K rate
* When the extended result code configuration option is enabled, one of the following codes is append-
ed to the result code, depending on the type of error control connection:
V42bis – V.42 error control (LAP-M) and V.42bis data compression
V42 – V.42 error control (LAP-M) only
MNP5 – MNP 4 error control and MNP 5 data compression
MNP4 – MNP 4 error control only
NoEC – No error control protocol