Muratec MFX-1950 All in One Printer User Manual


  Open as PDF
of 198
 
4-6 se n d I n G f a x e s
Real-time transmission (non memory transmission)
Your machine will simply dial the other fax and when it makes contact, your machine
will feed the document through, scanning and transmitting real time
•Withrealtimetransmission,youcanwatcheachpageasitisscannedandsent.
To perform a real time transmission:
1
Switch to the fax mode by pressing
<
c o p y
4
f a x
4
s c a n
>
.
2
Place the document on the ADF.
NOTE: •Thedocumentglasscannotbeusedforrealtimetransmission.
•ThedocumentglassisavailableonlyfortheMFX-1950.
3
Obtain a dial tone, either by:
•Pressing<AdvancedFunctions>repeatedlyuntil“Monitor”appears,andthen
press <Enter>.
– or –
Pressing the “Monitor” soft key
–or–
•Liftthehandsetifyouhaveconnectedanexternaltelephonetoyourmachine.
In either case, the machine shows:
** Tel Mode **
_
– or –
Press <Advanced Functions> repeatedly until “Memory Tx” appears and press
<Enter>. Then select “Off” and press <Enter> to turn off the memory transmission.
– or –
If you assigned “Memory Tx” to a soft key (page 8-2), turn off the memory transmission
by simply pressing that key.
NOTE: “Monitor” is a default soft key on the F-315.
4
Dial the fax number.
•Usethenumerickeystodialthenumber.
–or–
•Pressaone-touchkey.(Seepage 3-6.)
–or–
•Press<SpeedDial/Group>andthree-digitcode.(Seepage 3-8.)
–or–
•Usethephonedirectorydialing.(Seepage 3-11.)
NOTE: With real time transmission, only one destination can be dialed.
5
When you hear fax tones from the remote unit, press <Start>.
If a person answers the phone, use the handset to tell that person that you are trying
to send a fax. When you hear fax tones, press <Start>.
If the call fails and you used “Monitor” to dial, p
ress <Advanced Functions> repeatedly
until “Monitor” appears, then press <Enter> or press the “Monitor” soft key
to hang up.
If you are using the handset, hang up after pressing <Start>.
NOTE: To cancel the transmission, use Review commands features. (See page 4-8.)
 previous next