Filter
Top Products
Chapter 5 AT Serial Hardware Installation, Verification, and Configuration
© National Instruments Corporation 5-3 Serial Hardware and Software for Windows
Figure 5-1. AT Serial Board Installation
7. Screw the AT serial board mounting bracket to the back panel
mounting rail of the computer.
8. Replace the cover.
9. Turn on your computer and start Windows 2000.
10. Windows 2000 should automatically detect your hardware and display
the Found New Hardware Wizard. Complete the wizard by clicking
Next in each window and then Finish.
If the Found New Hardware Wizard does not appear, refer to the
Forcing Windows to Detect Your Hardware section in Appendix D,
Troubleshooting and Common Questions.
The serial hardware installation is complete. Continue to the next section,
Verify the Installation.
1PC 2ATSocket 3 AT Serial Card
1
2
3