Filter
Top Products
4-62
Upgrading Your System
This procedure summarizes the installation of the UPS. For detailed information
about:
UPS Refer to:
Features Uninterruptible Power Supply User’s Manual
Installation This Rack User’s Manual
PowerChute
®
plus
PowerChute
®
plus
User’s Guide
!
WARNING
It is required that a minimum of two people lift the UPS into
the tower cabinet. The UPS weighs a minimum of 112 lbs.
(50.9 kg).
Note:
The battery inside the UPS is disconnected for
shipment. Do Not install or connect any power cords to the
UPS before connecting its battery. Once the battery is
connected, Do Not disconnect it. The UPS power loads will
be unprotected, if the battery connector is removed.
1.
Observe the safety and ESD precautions listed at the beginning of this
chapter.
2.
Connect the battery inside the UPS (see Figure 4-68) as follows:
!
Grasp the right side of the front cover and remove it from the UPS. Set it
aside for reinstallation later.
!
Inside the battery compartment, locate the loose connector on top of the
battery (next to the white cord) and plug it into the open battery
connector. Make sure that you firmly press it into the connector and that
it is secured.
!
Reinstall the front cover of the UPS.
Figure 4-68. Connecting the UPS Battery