NetComm N300 Network Router User Manual


 
YML9WMAXXN ADSL2+ Wireless N300 Modem Router with VoIP User Guide
www.netcomm.com.au 11
NetComm Gateway
TM
Series - ADSL2+ Wireless N300 Modem Router with VoIP
Web User Interface
This section describes the setup procedure to access the web user interface.
3.1 Login Procedure
Follow these steps to login to the web user interface.
1: OpenanInternetbrowser(e.g.MicrosoftInternetExplorer)andenterthedefaultIPaddressfortherouterintheURLaddresseldat
top. For example, if the IP address is 192.168.1.1, enter “http://192.168.1.1”.
2: Next, you will be prompted to enter your user name and password. Enter admin as the user name and admin as the password,
and then click OK. These values can be changed later (see section 8.5.3).
3: After successfully logging in, you will reach the Quick Setup menu.
3.2 Default Settings
The following list shows the factory default settings for this router.
• LAN port IP address: 192.168.1.1
• Local administrator account name: admin
• Local administrator account password: admin
• Local non-administrator account name: user
• Local non-administrator account password: user
• Remote WAN access: disabled (except for ICMP)
• Remote WAN access account name: support
• Remote WAN access account password: support
• NATandrewall:DisabledforMER,IPoAandBridgemodesEnabledforPPPoEandPPPoAmodes
• DHCP server on LAN interface: enabled
• WAN IP address: none
• Wireless access: enabled
• SSID: Netcomm Wireless
• Wireless authentication: enabled Password a1b2c3d4e5
• Annex A enabled / Annex M disabled
This router supports the following connection types.
• PPP over Ethernet (PPPoE)
• PPP over ATM (PPPoA)
• MAC Encapsulated Routing (MER)
• IP over ATM (IPoA)
• Bridging
Technical Note:
Duringpoweron,thedeviceinitializesallsettingstodefaultvalues.Itwillthenreadthecongurationprolefromthepermanentstoragesectionofashmemory.Thedefault
attributesareoverwrittenwhenidenticalattributeswithdifferentvaluesarecongured.Thecongurationproleinpermanentstoragecanbecreatedviathewebuserinterface
ortelnetuserinterface,orothermanagementprotocols.Thefactorydefaultcongurationcanberestoredeitherbypushingtheresetbuttonformorethanvesecondsuntilthe
power indicates LED blinking or by clicking the RestoreDefaultCongurationoptionintheRestoreDefaultscreen,section8.1.3.