Filter
Top Products
YML9WMAXXN ADSL2+ Wireless N300 Modem Router with VoIP User Guide
www.netcomm.com.au 47
NetComm Gateway
TM
Series - ADSL2+ Wireless N300 Modem Router with VoIP
The graphic below shows an example of three protocols over the same connection.
8.1.2 MSP
Multi-Service over PVC (MSP) supports multiple protocols over a single connection. As with the VLAN Mux function, PPPoE, Bridge and
MER protocols can coexist, while IPoA and PPPoA are not supported. This function supports remote management by bridge protocol in
addition to multimedia applications over a single PVC.
Conguring MSP is a two-part process:
Part 1 - Create multiple PVCs (One Bridge + multiple PPPoE / One MER)
Part 2 - Use Port Mapping to connect LAN / WAN interfaces
NOTE: The example below shows how to configure a Bridge / PPPoE MSP connection. Use the same process for
Bridge / MER MSP connections.
If QoS is congured on the rst MSP connection, it will be congured by default for all subsequent connections.
If a MSP connection is removed every other MSP connection should be removed to avoid port mapping conguration problems.
Part 1 – Create Multiple PVCs
On the Advanced – WAN screen, create one PPPoE connection and one Bridge connection on the MSP supporting PVC. The screen will
display as follows.
Part 2
Go to Advanced – Port Mapping screen (see section 9.9 Port Mapping) and select the Enable Virtual Ports checkbox. The screen will
display as follows.
NOTE: Only hardware ports and bridge PVCs are listed as interfaces. The bridge interface is shown as “nas_x_y_z” where x=port, y=vpi, and z=vci.
To continue, click the Add button at the bottom of the screen shown above.