Filter
Top Products
YML864 Rev1 NB504 User GuideNB504 User Guide
www.netcomm.com.au 11
3.3 Connecting the Router
Before you install the router, you should connect your PC to the Internet through your broadband service
successfully. If there is any problem, please contact your ISP. After that, please install the router according to
the following steps. Don’t forget to pull out the power plug and keep your hands dry.
1. Power off your PC, Cable/DSL modem, and the router.
2. Locate an optimum location for the router. The best place is usually near the center of the area in which
your PC will wirelessly connect. The place must accord with the Installation Environment Requirements.
3. Adjust the direction of the antenna. Normally, upright is a good direction.
4. Connect the PCs and each Switch/Hub in your LAN to the LAN Ports on the router. (If you have the
wireless NIC and want to use wireless connector, you can skip this step.)
5. Connect the DSL/Cable Modem to the WAN port on the router.
6. Connect the AC power adapter to the AC power socket on the router, and the other end into an electrical
outlet. The router will start to work automatically.
7. Power on your PC and Cable/DSL modem.