NetComm NB504 Network Router User Manual


 
YML864 Rev1 NB504 User GuideNB504 User Guide
www.netcomm.com.au 13
Open a command prompt, and type ping 192.168.1.1, then press Enter.
If the result displayed is similar to that shown in figure 4-1, the connection between your PC and the router
has been established.
Figure 4-1 Successful result of Ping command
If the result displayed is similar to that shown in figure 4-2, it means that your PC has not connected to the
router.
Figure 4-2 Failed result of Ping command
Please check it following these steps:
1. Is the connection between your PC and the router correct?
Note: The 1/2/3/4 LEDs of LAN port which you link to on the router and LEDs on your PC’s adapter should be lit.
2. Is the TCP/IP configuration for your PC correct?
Note: If the router’s IP address is 192.168.1.1, your PC’s IP address must be within the range of 192.168.1.2 ~ 192.168.1.254, the
gateway must be 192.168.1.1