NB504 User Guide YML864Rev1
22 www.netcomm.com.au
5.3 Quick Setup
Please refer to Section 4.2: “Quick Installation Guide.”
5.4 Network
Figure 5-2 the Network menu
There are three submenus under the Network menu (shown in figure 5-2): LAN, WAN and MAC Clone. Click
any of them, and you will be able to configure the corresponding function. The detailed explanations for each
submenu are provided below.
5.4.1 LAN
You can configure the IP parameters of LAN on this page.
Figure 5-3 LAN
• MAC Address - The physical address of the router, as seen from the LAN. The value can’t be changed.
• IP Address - Enter the IP address of your router in dotted-decimal notation (factory default:
192.168.1.1).
• Subnet Mask - An address code that determines the size of the network. Normally use 255.255.255.0
as the subnet mask.
Note:
a. If you change the IP Address of LAN, you must use the new IP Address to login the router.
b. If the new LAN IP Address you set is not in the same subnet, the IP Address pool of the DHCP server will not take effect, until they are re-
configured.
c. If the new LAN IP Address you set is not in the same subnet, the Virtual Server and DMZ Host will change accordingly at the same time.