NetComm NB504 Network Router User Manual


 
YML864 Rev1 NB504 User GuideNB504 User Guide
www.netcomm.com.au 61
5.8.5 Remote Management
You can configure the Remote Management function on this page shown in figure 5-39. This feature allows
you to manage your Router from a remote location, via the Internet.
Figure 5-39 Remote Management
Web Management Port - Web browser access normally uses the standard HTTP service port 80. This
router’s default remote management web port number is 80. For greater security, you can change
the remote management web interface to a custom port by entering that number in this box provided.
Choose a number between 1024 and 65534, but do not use the number of any common service port.
Remote Management IP Address - This is the current address you will use when accessing your router
from the Internet. The default IP Address is 0.0.0.0. It means this function is disabled. To enable this
function, change the default IP Address to another IP Address as desired.
To access the router, you will type your router’s WAN IP Address into your browser’s Address (in
IE) or Location (in Navigator) box, followed by a colon and the custom port number. For example, if
your Router’s WAN address is 202.96.12.8 and you use port number 8080, enter in your browser:
http://202.96.12.8:8080. You will be asked for the router’s password. After successfully entering the
password, you will be able to access the router’s web-based utility.
Note: Be sure to change the router’s default password to a very secure password.