Filter
Top Products
FS728TP Smart Switch Software User Manual
Configuring the Device Using Your Browser 5-88
v2.0, November 2006
Defining General QoS Settings
The CoS Page contains information for enabling QoS globally and on specific interfaces. After
QoS has been configured, the original device QoS default settings can be reassigned to the
interface in the CoS Page.
To enable QoS:
1. Click Switch > QoS > General > CoS. The CoS Page opens:
The CoS Page contains the following:
– CoS Mode – Determines whether QoS is enabled on the device. The possible values are:
– Enable – Enables QoS on the interface.
– Disable – Disables QoS on the interface.
– Trust Mode – Defines which packet fields to use for classifying packets entering the
device. When no rules are defined, the traffic containing the predefined packet CoS field is
mapped according to the relevant trust modes table. Traffic not containing a predefined
packet field is mapped to best effort. The possible Trust Mode field values are:
Figure 5-57