Filter
Top Products
GS700TR Smart Switch Software Administration Manual
Maintenance 8-13
v1.0, May, 2008
2. Click Cancel to cancel the operation on the screen and reset the data on the screen to the latest
value of the switch.
3. Click Apply to send the ping. The switch will send the number of pings configured and the
results will be displayed below the configurable data.
• If successful, you will see “Reply From IP/Host: icmp_seq = 0. time = xx usec. Tx = x, Rx
= x Min/Max/Avg RTT = x/x/x msec”
• If a reply to the ping is not received, you will see “Reply From IP/Host: Destination
Unreachable. Tx = x, Rx = 0 Min/Max/Avg RTT = 0/0/0 msec”
TraceRoute
You can use the TraceRoute utility to discover the paths that a packet takes to a remote destination.
To display this page:
1. Click Maintenance > Troubleshooting > TraceRoute in the navigation tree.
Table 8-6. Ping Fields
Field Description
Hostname/IP Address Enter the IP address or the host name of the station you want the switch
to ping. The initial value is blank. This information is not retained across
a power cycle.
Count Specify the number of pings to send. The valid range is 1 to 15.
Interval Specify the number of seconds between pings sent. The valid range is 1
to 60.
Size Specify the size of the ping packet to send. The valid range is 0 to
65507.
Ping Displays the results of the ping.