Filter
Top Products
GS700TR Smart Switch Software Administration Manual
Configuring System Information 2-13
v1.0, May, 2008
2. To add an SNTP server, select Add, complete the remaining fields as desired, and click Apply.
The SNTP server is added, and is now reflected in the Server list. You must perform a save to
retain your changes over a power cycle.
3. To removing an SNTP server, select the IP address of the server to remove from the Server
list, and then click Delete. The entry is removed, and the device is updated.
4. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
5. If you change any of the settings on the page, click Apply to send the updated configuration to
the switch. Configuration changes take effect immediately.
SNTP Server Status
The SNTP Server Status page displays status information about the SNTP servers configured on
your switch.
To access the SNTP Server Status page:
1. Click System > Management > Time > SNTP Server Configuration in the navigation
menu.
Port Enter a port number from 1 to 65535. The default is 123.
Priority Specifies the priority of this server entry in determining the sequence of
servers to which SNTP requests are sent. Enter a priority from 1 to 3,
with 1 being the default and the highest priority. Servers with lowest
numbers have priority.
Version Enter the protocol version number. The range is 1-4.
Figure 2-7
Table 2-5. SNTP Server Configuration Fields (continued)
Field Description