Filter
Top Products
GS700TR Smart Switch Software Administration Manual
3-8 Configuring Switching Information
v1.0, May, 2008
2. Click Refresh to reload the page and display the most current information.
3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to the
latest value of the switch.
4. If you make any changes to this page, click Apply to send the updated configuration to the
switch. Configuration changes take effect immediately.
LACP Port Configuration
To display the LACP Port Configuration page:
1. Click Switching > LAG > Advanced > LACP Port Configuration in the navigation tree.
Figure 3-5
Table 3-5. LACP Configuration Fields
Field Description
LACP System Priority Specifies the device’s link aggregation priority relative to the devices at
the other ends of the links on which link aggregation is enabled. A
higher value indicates a lower priority. You can change the value of the
parameter globally by specifying a priority from 0 to 65535. The default
value is 32768.