Filter
Top Products
NETGEAR ProSafe 802.11g Wireless Access Point WG102 Reference Manual
Basic Installation and Configuration 1-9
v1.0, July 2008
Using a computer with an 802.11b or 802.11g wireless adapter with the correct wireless
settings needed to connect to the WG102 Access Point (SSID, WEP/WPA, MAC ACL, etc.),
verify connectivity by using a browser such as Netscape or Internet Explorer to browse the
Internet, or check for file and printer access on your network.
Logging in to the Wireless Access Point
The default IP address of your access point is 192.168.0.229. The WG102 Access Point is set, by
default, for the DHCP client to be disabled.
1. Open a Web browser such as Internet Explorer or Netscape Navigator.
2. Connect to the WG102 Access Point by entering its default address of http://192.168.0.229
into your browser.
Note: If you are unable to connect, see Chapter 5, “Troubleshooting
Note: The computer that you use to connect to the WG102 Access Point should be
configured with an IP address that starts with 192.168.0.x and a Subnet Mask of
255.255.255.0.
Figure 1-6