Filter
Top Products
A-1
v1.0, July 2008
Appendix A
Factory Default Settings and Specifications
Factory Default Settings
When you first receive your WG102 Access Point, the default factory settings are set as shown
below. You can restore these defaults with the Reset button on the rear panel — see
“Rear Panel”
on page 1-3.
Feature Factory Default Settings
User name (case sensitive) admin
Password (case sensitive) password
Operating mode Access point
Access point name netgearxxxxxx where xxxxxx are the last six digits of the
wireless access point's MAC address
Built-in DHCP client DHCP client disabled, it uses the default IP address
IP configuration IP Address: 192.168.0.229
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
Network Name (SSID) NETGEAR-0-0
Broadcast Network Name (SSID) Enabled
Super-G mode Disabled
WEP/WPA Disabled
MAC Access Control Disabled
Restricting connectivity based on MAC Access
Control List
Disabled
Time Zone GMT
Time Zone Adjust for Daylight Saving TIme Disabled
SNMP Disabled
VLAN (802.1Q) Disabled
WMM support Disabled