Filter
Top Products
WNHDE111 5GHz Wireless-N HD Access Point/Bridge User Manual
Easy Secure Wireless Setup 2-5
v1.1, May 2008
Setting Up Two WNHDE111 Units
You can set up a pair of WNHDE111 units, for example if you purchase them as a bundle. Or, you
can set up one unit as an access point, then add a second unit as a bridge. Follow the instructions
below for either of these scenarios.
Setting Up a Pair of WNHDE111 Units at Once
Follow these steps to set up a pair of WNHDE111
1. Set the switch on the back of each Wireless-N AccessPoint/Bridge to Auto mode.
2. Connect the Ethernet cable from a LAN port in the router or gateway to either LAN port on
one Wireless-N AccessPoint/Bridge.
3. Place the other Wireless-N AccessPoint/Bridge near the media player, game console, or switch
and connect it with an Ethernet cable.
4. To complete installation, connect a power adapter to the Wireless-N Bridge(s). Allow a few
minutes for your devices to connect to the Internet.
Figure 2-5
Note: By following the steps in this installation with both Wireless-N Bridge units
set to Auto mode, the Wireless-N Bridge connected to your router has set itself
to AP mode, while the second Wireless-N Bridge is set to Bridge mode.
Gaming console
WNHDE111
Router/gateway
Internet
Digital Media Adapter
WNHDE111
AP Mode
Bridge Mode