Filter
Top Products
DDR3THIN-MN-XXX 16 Doc. Rev. 1.11
The strain relief on the LEASH to NEXPRB1X/2X interface, while designed for bench handling,
can be damaged by twisting the coax cables. Bends of over 45 degrees in this area should be
avoided. The coax connection points, under any circumstances, are not to be bent.
3.5.1 Samtec connector on the LEASH probe pins
Figure 2 – Samtec connector on the LEASH probe
The LEASH probe connects to the NEX-PRB1X-T or NEX-PRB2X-T probe using two plastic
nuts and screws, with a plastic spacer between the two boards. These parts are supplied.