Filter
Top Products
11
Note: If the operating system or the browser is set to use an
HTTP proxy server, either turn off the setting or put the
Wireless Gateway's IP address in the list of unproxied hosts.
3. Power up the Wireless Gateway and wait about 15 seconds while it boots up.
4. Command the browser to access the following URL:
http://192.168.0.254/
Note: If you have accessed the configuration utility and changed the IP address of
the Wireless Gateway before, use the factory reset button to reset the unit. Or
alternatively, you can enter the new IP address as the URL and make sure the
computer use a corresponding IP address. For example, if you have changed the
IP address to 172.16.100.1, use it as the URL and make sure the computer have an
IP address in the range of 172.16.100.2 through 172.16.100.254. In addition, if
you have changed the subnet mask, the computer must have the same subnet mask
too.
The configuration utility's initial display will appear and divide the browser window
into three sections:
• A
menu bar
at the top of the window contains the names of the utility's
top-level menus. This bar never changes.
• A
command panel
at the left edge of the window contains the commands in
the current menu.
• A
settings panel
occupying the rest of the window contains either buttons,
input boxes, and other controls for changing device settings, or information
about the Wireless Gateway.
The following sections explain the items in the settings panels under each of the
configuration utility's menus.