Filter
Top Products
66
The Reset command restarts the Wireless Gateway just like turning the device off and
on. Saved settings are retained, but tally counters are restarted from zero after the
reset. The Reset panel contains the message “Do you really want to reset this device?”
and a YES button. If you do not want to reset the Wireless Gateway, exit the panel
without clicking YES; otherwise, click YES and the reset process will begin.
Tools — Factory Reset
A factory reset restarts the Wireless Gateway and returns all of its settings to their
default values. The Factory Reset panel contains the message “Do you really want to
factory reset this device?” and a YES button. If you do not want to carry out a factory
reset, exit the panel without clicking
YES
; otherwise, click
YES
and the factory reset
process will begin.
Note: The Wireless Gateway must be reconfigured after a factory
reset.
Tools — Print Test
The Print Test command lets you test an attached printer and the connection to it. The
Print Test panel contains a Port Selection control and a Test button. The Port
Selection
control is permanently set to
LPT
, the internal name for the Wireless
Gateway's printer port.
To test the printer and the connection to it, click the Test button. If a connection to a
printer can be detected, the message “LPT: On line” will appear and a Test Page will
be printed out to the printer; otherwise, “LPT: Off line” will be displayed.
Tools — PPPoE Connect and PPPoE Disconnect
If the Wireless Gateway is set for a PPPoE (Point-to-Point Protocol over Ethernet)
WAN connection and the
Connect on Demand
control is set to
No
(see “Basic
Setup — Broadband Router”), you can use the PPPoE Connect and PPPoE
Disconnect commands to turn the link to your ISP on and off.
Note that if you are using a manager console, and connection scheduling is in effect
(see “Advanced Settings — Manager Console”), the PPPoE Connect command will
work only when the schedule allows connection to the WAN.
When you click PPPoE Connect, there might be a delay of a few seconds; then the
message “PPPoE Connecting...” will be displayed until connection is successful. If for