Filter
Top Products
46
MAC address is 0080C82F8086, which may also be written as 0080c82f8086,
0080C8 2F8086, or 00 80 C8 2F 80 86. The first step in creating a User List
entry is to click in the MAC Address input box and type the station's MAC
address, with or without spaces.
The Wireless Access control is for specifying whether the wireless station
with the specified MAC address will be allowed access or not. Click Yes to
allow access, No to deny it.
The
Add
button stores the MAC Address and Wireless Access controls'
settings in the Wireless Gateway's non-volatile memory.
The Delete button is used in conjunction with the drop-down list box next to it.
(Note that in some browsers, the list box appears only if there is at list one
entry in the User List.) These two controls are for removing entries from the
list. To remove an entry, open the list and click or drag to the unwanted entry;
then click Delete.
Access Control
The Access Control section of the Wireless Access panel turns the User List
on and off, and controls whether non-listed wireless stations are allowed
access or not.
The Enable/Disable control puts the User List into effect (“enables” it) or
causes it to be ignored (“disables” it). Click the appropriate setting.
The Other Users Wireless Access control determines whether unlisted
wireless stations will be allowed access or not. Clicking Yes allows them
access, clicking No denies it.
The
Save
button stores the settings of the Enable/Disable and Other Users
Wireless Access controls in the Wireless Gateway's non-volatile memory. The
settings take effect immediately after being saved.