Filter
Top Products
Management
DRAFT
E Copyright Nokia Telecommunications Oy
NTC C33539002SE_A0
5-55
Command Enable/disable RIP receive function
Description Specifies whether the M10 should use Routing informa-
tion protocol (RIP) broadcasts to update its routing
tables with information received from other routers on
your network. RIP cannot be activated if address map-
ping is ON.
Syntax set ip ethernet rip_receive [off | v1 | v2 | v1-compat]
Arguments Both RIP version 1 and RIP version 2 functionalities
can be simultaneously activated. v1-compat argument
enables the receiving of both RIPv1 and RIPv2 packet-
s.
Example m10> set ip ethernet rip_receive off
Command Enable/disable default gateway
Description Specifies whether the M10 should send packets to a
default gateway if it does not know how to reach the
destination host.
Syntax set ip gateway option [on|off]
Arguments The argument enables/disables the default gateway op-
tion.
Example m10> set ip gateway option on
Command Select gateway interface
Description Specifies how M10 should route information to the de-
fault gateway.
Syntax set ip gateway interface [ip_address | ppp_vccx]
Arguments
If you select ip_address, you must enter the IP ad-
dress of a host acting as a default gateway on a local
or remote network. If you specify a PPP on ATM chan-
nel, the M10 uses the default gateway being used by
the remote PPP peer behind that ATM channel. Accept-
able values for ’x’ are the ATM channels using ppp–
vcmux encapsulation.
Example m10> set ip gateway interface ip-address