Filter
Top Products
22 Installing Device Manager software
If several warning messages are displayed after you launch Device Manager
on a Solaris workstation, do the following:
•
Add the following statement to your .cshrc file:
setenv XKEYSYMDB $HOME/ .XKeysymDB
•
Make sure there is a .XKeysymbDB file in your home directory.
Executing the Device Manager installation software on UNIX
Use this procedure to execute the Device Manager installation software in
a UNIX environment.
Procedure steps
Step Action
1
Close all programs.
2
Navigate to the directory on your system where you loaded the
Device Manager software.
3
For the Linux environment, make the file executable by entering:
chmod a+x jdm_ xxxx_linux.sh
For the Solaris environment, make the file executable by entering:
chmod a+x dm_xxxx_solaris_sparc.bin
4
For the Linux environment, run the jdm_xxxx_linux.sh file.
For the Solaris environment, run the dm_xxxx_so-
laris_sparc.bin file.
An installation screen, followed by a Nortel dialog box opens.
Then, the Introduction dialog box appears (see "InstallAnywhere
Introduction dialog box" (page 23)).
Nortel Metro Ethernet Routing Switch 8600
Fundamentals — Using Device Manager
NN46225-300 02.02 Standard
4.2 1 October 2007
Copyright © 2005-2007, Nortel Networks
.