Filter
Top Products
703t server description Standard 1.04
30 CallPilot
Supported peripheral devices
This section identifies external devices that are supported by the 703t
server. The following table describes the supported peripheral devices:
Device Description
Modem A 56 Kbps external modem (NTRH9078 in North America
only) provides remote access to the 703t server. The modem
connects to the RS-232 COM1 connector on the rear of the
server.
Because the modem is an external device, it requires its own
AC power source referenced to the same ground as the 703t
server and the switch to which it is connected.
Ethernet hub A 10Base-T Ethernet hub provides the ELAN connection
between the 703t server and the Meridian 1 switch or
Succession 1000 system. The customer can supply a hub or
switch from third-party vendors or from Nortel.
Because the hub is an external device, it requires an AC
power source referenced to the same ground as the 703t
server and the switch to which it is connected.
ATTENTION
To comply with EMC requirements, a Class A hub must be
located 10 m (33 ft.) away from the 703t server.
Monitor, keyboard,
and mouse
15-inch monitor: NTRH9011 or N0038380 LCD monitor
Because the monitor is an external device, it requires its
own AC power source referenced to the same ground as
the 703t server and the switch to which it is connected.
Keyboard: NTRH9013
Mouse: NTRH9014