October 2006 Installing the server and connecting the peripheral devices
703t Server Hardware Installation 55
To connect the mouse, keyboard, and monitor to the
server
1 Place the monitor, keyboard, and mouse in the same location as the
server.
2 Plug the keyboard and mouse into the appropriate PS/2 connectors on
the chassis rear panel. See the diagram on page 54.
3 Plug in the monitor connector. Tighten the screws on the connector.
4 Ensure that a single-point ground reference is available for all the power
outlets serving the CallPilot server and its peripherals. Before the
CallPilot server installation, a qualified electrician must implement the
single-point ground reference requirement between the power outlets of
the CallPilot server and the power outlets of the switch.
5 Connect the power cord to the monitor, and plug the other end into a wall
receptacle or power bar.
6 Turn on the monitor.
To connect the modem to the server
1 Ensure that the modem’s AC power cord is not plugged in.
2 Connect the large 25-pin male connector to the back of the modem.
Tighten the connector screws.
3 Connect the 9-pin female connector to COM1 port at the rear of the
server. Tighten the connector screws.
4 Connect one end of the telephone cable to the modem RJ-11 jack
labeled LINE.
5 Connect the other end of the telephone cable to the RJ-11 jack in the
wall.
6 Ensure that a single-point ground reference is available for all the power
outlets serving the CallPilot server and its peripherals. Before the
CallPilot server installation, a qualified electrician must implement the
single-point ground reference requirement between the power outlets of
the CallPilot server and the power outlets of the switch.