Filter
Top Products
October 2006 Installing the server and connecting the peripheral devices
703t Server Hardware Installation 65
To connect the server to power
1 Plug the server’s AC power cord into the server’s rear panel.
2 Plug the other end into a wall receptacle or power bar.
To start the server
1 Press the server power switch to start the server.
2 Observe the Power-On Self Test (POST) and initialization messages on
the monitor.
3 Let the mini-setup sequence run until you are prompted to log in to the
operating system.
Note: The system may perform multiple reboots. This is normal.
4 Ensure that the operating system logon window appears on the monitor.
Note: If the logon window does not appear, refer to the CallPilot
Maintenance and Diagnostics guide for your server for troubleshooting
instructions.
5 Proceed with the CallPilot server and switch configuration guide for your
switch to connect and configure the server and switch.
.
WARNING
Risk of personal injury and risk of hardware failure
You must connect the power outlets that are used by the
CallPilot server and its peripheral devices to the same
single-point ground reference as the one used by the switching
system connected to the CallPilot server.
If this requirement is not met, power transients can cause
personal injury, hardware failure, or both. For more information
on single-point grounding requirements, refer to the Installation
and Configuration Task List (555-7101-210).