Installing the server and connecting the peripheral devices Standard 1.04
58 CallPilot
Connecting the server to the ELAN
Connect the CallPilot server to the Meridian 1 switch or Succession 1000
system using the Embedded LAN (ELAN).
To connect the server to the ELAN (Meridian 1 or
Succession 1000 only)
1 Locate the ELAN Ethernet connector on the back of the server.
Note: The ELAN connector is labeled as NIC1 10/100 MB. For the
connector location, see the diagram on page 54.
2 Connect an RJ-45 network cable from the ELAN hub to the server’s
ELAN connector.
Note: The ELAN hub is optional if you use a cross-over network cable to
make a direct point-to-point connection from the server to the switch.
However, if you choose to establish a direct point-to-point ELAN
connection, no other device can connect to the ELAN.
ATTENTION
For important considerations about using the ELAN in
your network, see the Planning and Engineering Guide
(555-7101-101).
ATTENTION
To comply with EMC requirements, a Class A hub must
be located 10 m (33 feet) away from the 703t server.