Filter
Top Products
62 Chapter 4 Installing option cards and DIMMs
NN46110-311 02.01
The first several times that you remove the front bezel, the bezel can stick
because the ball studs and socket clips are new.
To remove the top cover:
1 If the gateway is in an equipment rack, remove it from the rack.
a At the front of the chassis, remove the two panhead screws that secure the
bottom of the chassis to the equipment rack.
b Remove the VPN Router 2700 from the rack-mount shelf, and set it on a
sturdy surface.
2 Use a Phillips screwdriver to remove the four screws that secure the cover to
the chassis (Figure 21).
Figure 21 Removing the top cover
3 Slide the top cover forward approximately 1/4 inch.
CS260006A
Remove these 4 screws
Slide cover forward and lift up
Boot/Ready
Alert
Alert
Boot/Ready