Filter
Top Products
27
R2MFC Card Installation and Configuration Guide
Chapter 3
Installing the R2MFC card
This chapters describes how to install and remove an R2MFC card in a host Norstar system.
This chapter provides the following installation and removal procedures:
• “Shutting down the system”
• “Installing an R2MFC card” on page 28
• “Removing an R2MFC card” on page 30
• “Wiring an R2MFC card” on page 31
Figure 5 provides an overview of the steps for installing the R2MFC card.
Figure 5 Overview of the R2MFC card installation
Shutting down the system
Before you shut down the system or perform any maintenance procedures, read the following
warnings to ensure you and your system are properly protected.
Warning: If you are installing a new Norstar, refer to the Installer guide for the host
system for instructions about installing a new system before you connect the system to
the AC power outlet.
Set card DIP
switches
Disconnect power from
unit
Install new R2MFC
Card
Restore power to
Norstar
Reconnect all cables
Monitor LEDs for power
and status
Continue with
system
initialization
Disconnect cables from
the KSU