Filter
Top Products
<7> Insert the toner/drum cartridge into the main unit.
18
1
36
19
T
E
L
L
I
N
E
<8> Remove the drum protective paper in the direction
indicated by the arrow.
<11> Remove the sealing tape from the toner/drum
cartridge by pulling it in the direction indicated by the
arrow.
<9>
Remove the supplied developer cartridge from the
packing case and remove the protective materials A and B.
<10> Shake the developer cartridge horizontally
approximately 5 times and insert it into the machine.
<12> Remove the sealing tape from the developer
cartridge in the direction indicated by the arrow.
<14> Close the front cover.
Gently close the cover.
<15> Apply pressure to the fusing roller.
Raise the right and left levers of the fusing unit in the
direction indicated by the arrow.
<16> Close the left door.
<17> Turn the lock pin a
1
/4 turn and remove it while
pressing down on the pressure plate.
5. Load paper.
<1> Pull out the paper tray.
Gently pull out the paper tray until it stops.
<2> Load paper into the tray.
Do not exceed the maximum height line. (up to 500 sheets
of OKI recommended paper can be loaded)
6.
Connecting the machine to a computer.
<1> Connect the machine to the computer
• When connecting to a parallel port:
The parallel interface of this machine conforms to
IEEE-STD-1284-1983.
Use a commercially available shielded type parallel interface
cable conforming to the specifications of both the machine
and the computer.
The connector on this machine is a 36-pin Amphenol female
connector.
For the specifications of the connector on the computer, see
the operation manual of the computer.
Parallel interface connector
<2> Insert the power plug into an outlet.
Caution
If the outlet is also used for lighting fixtures, the lighting
fixtures may flicker.
Use an outlet which is not connected to lighting fixtures.
<3> Turn on the main switch of the main unit.
Automatic level adjustment of toner density sensor will start
and a message indicating [WARMING UP] will appear on
the operation panel. After the level adjustment is complete,
the ready indicator will light up.
Caution
While automatic adjustment of the toner density sensor
is being done, do not turn the power to the machine off.
This will cause improper adjustment.
7. Check the printer operation
For installation of printer drivers on the computer refer to the
Operation manual (for printer operation and general
information) supplied with the machine.
After driver installation, execute a test print to ensure normal
printing.
<13> Return the developer unit lock to its original
position.
A
B
Remove the lock pin
while holding down on
the paper pressure
plate and insert the
paper tray into the main
unit.
* If another peripheral device must be installed,
carry out the following step at the end of the
installation work.
6