Filter
Top Products
<Before installation>
•
Carry out the installation after checking that the
DATA indicator on the operation panel is neither lit
nor blinking.
• For installing B83D, an optional desk (multi
purpose drawer, stand/3 x 500 sheet paper drawer
or stand/MPD & 2000 sheet drawer) must have
been installed.
• Ensure that the front mounting plates and the
rear mounting plates included with the optional
stand/paper drawer are securely attached.
•
Check that the left adjuster supplied with an
optional stand/drawer has been attached.
1. Turn off the main switch of the main unit of the printer.
2.
Remove the left side cover of the main unit of the printer.
Turn the main switch located on
the front side of the main unit of
the printer to the "OFF" position.
Then, remove the power plug of
the main unit of the printer from
the outlet.
Unlock the lock release
lever of the main unit of the
printer and then pull out the
left door.
Slide the two upper covers
up to remove them. Remove
the lower cover by inserting
a flat-blade screwdriver at
three locations ( ) shown in
the illustration.
Then, close the left door.
B83D Installation Manual
<1> Remove the screw that
fixes the harness cover of the
main unit of the printer and
then slide the harness cover
up to remove it.
4. Connect the harness to the main unit of the printer.
Top covers
Lower cover
Left door
<3> Connect the connector of
the relay harness of the
duplex module to the CN12
(white connector) of the PCU
PWB of the main unit of the
printer.
<4> Insert the snap bands to
the locations shown in the
illustration and fix them.
<5>Secure the earth harness
using a supplied M4 screw.
<2> Cut out the harness cover
as shown in the illustration.
Installation is now complete.
<6> Reattach the harness
cover to its original position
and fix it with the removed
screw.
Relay harness
connector
PCU PWB
Snap bands
Ground harness
M4 Screw
"
OFF
"
Lock release lever
<1> Hang the hooks located at
the upper part of the duplex
module on the openings of the
left door of the main unit of the
printer.
<2> Push the lower part of the
duplex module to insert the
positioning bosses securely
into the main unit of the printer.
<3> Tighten the two screws
built in the duplex module.
3.
Attach the duplex module to the main unit of the printer.
Hook
Positioning boss
Positioning boss
Hook
Duplex module
Harness cover
Screw
Harness cover
Screw
Cut out.
Harness cover
Relay harness
FOR USE WITH COMPATIBLE OKI DIGITAL PRINTERS.
SEE OKI DIGITAL PRINTER SERVICE MANUAL OR
INSTALLATION MANUAL TO DETERMINE SUITABILITY.
Parts included
M4 Screws
(M4x8) : 1 pcs.
5. Carry out the off center adjustment.
CN12
* If another peripheral device must be installed, carry out
the following step at the end of the installation work.
7