Filter
Top Products
Troubleshooting > 110
> Holding the complete assembly by its top centre, lower
it into place in the printer, locating the pegs at each
end into their slots in the sides of the printer cavity.
11. Lower the printer top cover but do not press down to latch
it closed yet. This will protect the drums from excessive
exposure to room lighting while you check the remaining
areas for jammed sheets.
12. Open the rear stacker and check for a sheet of paper in
the rear path area.
> Pull out any sheets found in this area.
> If the sheet is low down in this area and difficult to
remove, it is probably still gripped by the fuser. In this
case raise the top cover, reach around and press down
on the fuser pressure release lever (1).
1